Tools and Reviews Tablesaws Tablesaw Miter-Gauge Extension A telescoping stop for your saw. By WOOD Magazine Staff WOOD Magazine Staff Launched in 1984, WOOD® magazine is the world's most trusted woodworking resource — a distinction we've earned by guaranteeing our readers' success in their woodworking shops. It is the mission of our staff to inspire and inform woodworkers at every stage of their journey by providing reliable and accurate project plans, woodworking techniques, and product reviews. WOOD magazine's Editorial Process Published on July 11, 2016 When making repetitive tablesaw crosscuts, you typically clamp a stop on a miter gauge auxiliary fence and cut with confidence. But what do you do when the length of the cut extends beyond the face of the miter gauge? To solve the problem, I made a telescoping stop for my saw, as shown. In a length of 1⁄2 " steel pipe, I drilled a pair of holes for the knurled knobs, where indicated in the drawing, tapped them; and threaded a knob in each. Then, in one end of a 1⁄2 " steel rod about the same length as the pipe, I drilled a 1⁄4 " hole and attached a bolt as shown in the Stop Detail. I drilled and tapped holes in the bottom of my tablesaw top and used metal strapping to secure the pipe to the table. Now, with the rod inserted in the pipe, I can slide the stop out to whatever length I need and tighten it in place with the knobs. When not in use, the stop slides all the way into the pipe.—David Mattichak, Port Republic, Va. If you like this project, please check out more than 1,000 shop-proven paper and downloadable woodworking project plans in the WOOD Store. Was this page helpful? Thanks for your feedback! Tell us why! Other Submit